90/D1/D2/RRC MEDIUM LOAD REAR SPRINGS
Stock Code: TF023VTERRAFIRMA MEDIUM LOAD SPRINGS FOR DEFENDER 90, DISCOVERY 1 & 2 AND RRC.
WILL PROVIDE AROUND 2" OF LIFT WHEN CARRYING UP TO 200kg. THIS EQUATES TO A WELL EQUIPPED OFF ROAD OR EXPEDITION VEHICLE WITH A CONSTANT MEDIUM TO HEAVY LOAD. CAN BE USED ON THE DISCOVERY 2 BUT WILL NOT CARRY THE SAME LOAD AND MAY NOT ACHIEVE 2" OF LIFT.
Terrafirma Coil Springs are designed to lift the
vehicle by approximately 2” (50mm).This is
the optimum increase in ride height before the
mechanical limitations of the suspension design
become an issue requiring further modifications.
Safety has to be a consideration, raising the centre
of gravity too high increases the risk of a roll over.
A vehicle lifted by 2” (50mm) using correctly
matched Terrafirma Coil Springs and shocks will
also improve on road handling, comfort and stability from the original set up.
Terrafirma Coil Springs are made from the highest quality steel, formed on accurate computer controlled mandrels and precisely heat treated to ensure consistent manufacture. All springs are shot peened to relieve stress and scragged to ensure long spring life and prevent sag, finally powder coated silver for long lasting good looks.
Correct Coil Spring Selection
It is important to understand that all Terrafirma Coil Springs have been designed to provide approximately 2” (50mm) of lift while carrying light, medium or heavy loads. Minimal mechanical changes are required when lifting by this amount, however the Terrafirma Hardware range of accessories does allow for greater lift and significantly increased wheel travel, further enhancing off-road ability.
Selecting the most suitable springs for a Land Rover may be with some compromise. A heavy load spring needed when fully loaded may ride too high and too hard when unloaded. Likewise a light load spring that is comfortable
and flexible will not achieve the desired lift or carry the heavy loads associated with expedition vehicles.
Load carrying coil springs are often progressive or variable (V) this provides a combination of comfort and load carrying in one spring.
It is worth noting that Terrafirma coil springs are sold in pairs, in many cases one spring is 10mm longer than the other, the longer spring should always be fitted to the driver’s side.
By considering the three Defender images and combining the Terrafirma Coil Spring application guide and specifications it should be possible to select suitable coil springs or a suspension kit for your vehicle. Use the detailed spring descriptions by part number to help accurately fine tune the spring requirements for your specific application.